Flooring Company In Cary, NC

Yes. We come to your house in Cary, measure, look at the subfloor, and talk through what you want. A written quote shows up in your email within a day or two. It costs nothing, and you don’t owe us anything if you decide not to go ahead.

For the Triangle in 2026, solid hardwood usually runs $8 to $14 a square foot installed, and engineered hardwood runs $7 to $12. Where you land in that range depends on the species, the plank width, the layout, and what has to come out first. Pulling up glued-down flooring or old tile takes longer than pulling carpet, and a subfloor that needs leveling adds time too. If you already have hardwood hiding under carpet, refinishing it usually costs far less than replacing it. We give you a fixed written price after we measure, so the number you sign is the number you pay.

A typical 1,000 square foot hardwood installation takes three to five days. LVP and laminate go faster, often one or two days for the same area. Refinishing existing hardwood takes three to four days because each coat needs time to dry. Most epoxy garage floors take a day or two, depending on prep and cure. Tile depends on the layout and the prep work. What usually throws a schedule off is a subfloor problem nobody looked for, so we check for that when we come out to measure.

Usually, yes. Most houses from that era have solid oak that’s three-quarters of an inch thick, and solid hardwood can be sanded and refinished several times over its life. A quick way to check is to lift a floor vent cover and look at the edge of the board. If there’s a healthy amount of wood above the tongue, there’s plenty left to sand. Engineered flooring is a different story. Its top layer can be thin, and some engineered floors can only be sanded once, or not at all. We’ll look at yours during the estimate and tell you plainly whether it’s a refinish or a replacement.

Most of that orange comes from the old oil-based finish, which ambers as it ages, plus the natural color of red oak. Sanding to bare wood takes the old finish off, and a water-based finish stays much clearer than oil, so the floor won’t drift back toward orange. Red oak still has a pink undertone, though. If you’re after the light, natural look you see in a lot of newer houses, a stain or a tinted sealer can tone the pink down. Stain looks different on every floor, so we put samples on your own boards and you choose in your own light.

For most families with pets, LVP is the easier floor to live with. It’s waterproof, it resists scratches, and an accident on the floor won’t turn into a subfloor problem. That’s a big part of why it’s the floor we install most often. If you want real wood anyway, you can make it work. Pick a hard species like white oak or hickory, go with a wire-brushed texture instead of smooth, and keep the sheen matte or satin. A character grade with knots and color variation hides wear well, too. Then put a mat at the door the dog uses most and keep nails trimmed. That handles most of the damage we get called out for.

Yes, but each one needs a different approach. Over a crawlspace, solid or engineered hardwood both work on a plywood subfloor, as long as the moisture under the house is under control. A torn vapor barrier or a damp crawlspace in a North Carolina summer can cup a brand-new floor within months, so we check moisture before anything goes down. On a concrete slab, solid hardwood isn’t the right call. Engineered hardwood is built for it, and LVP works well too. Checking the slab is part of the free estimate.

We do, along with basements, workshops, and commercial floors. You can go with a solid color, a metallic finish, or a flake system, and we use polyurea, polyaspartic, or acrylic topcoats depending on how the space gets used. Most garages take one to two days. Prep is where epoxy jobs succeed or fail, so we check the slab for moisture and old coatings before we recommend anything. If a garage floor has been peeling, bad prep is usually the reason.

Yes to both. We’re licensed and insured, and we carry general liability and workers’ comp on every crew member. Many Cary neighborhoods, Preston, Lochmere, and Amberly among them, have HOAs, and some ask for a certificate of insurance before a crew starts work. Give us the contact and we’ll send it straight to your HOA, builder, or property manager.

Most of the time, yes. It’s a common request in two-story houses, where someone pulls the carpet out of an upstairs hall or a bonus room and wants it to look like the oak downstairs, or where an addition has to tie into the original floor. We match species, plank width, stain, and sheen as closely as the material allows. Sometimes the cleanest result comes from refinishing the old floor and the new section together, so they finish the same color.

Usually not. Our sanding is dust-contained, so the fine dust stays out of your vents and off your furniture. You do have to stay off the floor while each coat dries, so when the layout allows, we work in sections and you keep access to a kitchen and a bathroom. Water-based finishes dry fast and have very little smell. Oil-based finishes give a warmer color, but you’ll smell them for several days. If someone in the house has asthma, or you have a baby, tell us and we’ll plan around it.

It can be. Laminate runs $3 to $6 a square foot installed, it handles scratches better than most wood, and when a couple of planks get damaged you replace those planks instead of redoing the room. Its weak spot is standing water. Laminate cores swell if water sits in a seam, so for rental kitchens, baths, and laundry rooms we usually recommend LVP at $4 to $8 instead. We work with landlords and property managers around the Triangle and can send insurance certificates whenever they’re needed.

Four questions cover most of it. Will the person giving the estimate be on the job, or does the work get handed to a subcontractor? Is the price fixed in writing, or is it a range that can climb once the old floor comes up? How long will the flooring sit inside the house to acclimate before it’s installed? And can they show you proof of general liability and workers’ comp? That last one matters because an uninsured worker who gets hurt in your house can become your problem. Ask every contractor you’re considering the same four questions. Here are our answers: Mario runs the crew and is on the job, the price is fixed and in writing, the material acclimates in your house first, and we’ll send our insurance certificate to anyone who asks.

We don’t run a third-party financing program. We take a deposit at the start, and the balance isn’t due until we’ve walked the finished job with you and you’ve signed off. We accept checks, all major credit cards, and bank transfers, and some homeowners pay by card to spread the cost out. We can also split a project into phases, say the main floor now and the bedrooms later, with a separate price for each. Call (919) 794-1116, tell us your budget, and we’ll tell you honestly what fits.

Hardwood is what we’re known for, but we also install LVP, laminate, tile, epoxy, and concrete floor coatings. Our tile work covers bathrooms, showers, backsplashes, and patios in porcelain, ceramic, natural stone, and large-format tile. We also have a cleaning crew that can come through after a flooring job. One company handling all of it means one schedule and one phone number to call.

Because we’re closer than the address makes it sound. Our shop at 237 Obie Dr is 20 to 25 minutes from most of Cary, and we’ve worked across the Triangle for 16 years with the same crew. When you search for flooring companies near me from Cary, you’ll see showrooms, big-box stores, and installers mixed together, and some of them sell the material and subcontract the install. We measure, quote, and install with our own people, which is the main reason our jobs finish the way they were quoted.

Start with the finish. If it’s worn through to grayish bare wood in the walkways, or the whole floor looks dull and scratched, refinishing will bring it back. If boards are badly cupped, feel soft underfoot, or have black stains where water or pet accidents soaked into the wood, those sections may need replacing first. Often it’s a mix of both: we replace the damaged boards, blend them in, and refinish the whole room so it matches. Most floors need refinishing somewhere between seven and fifteen years, depending on how hard the house is on them. We’ll give you a straight answer once we see the floor.

The request we hear most is white oak, natural or lightly stained, in planks around five to seven inches wide. Wire-brushed textures are still popular, and matte or low-sheen finishes have mostly pushed gloss out. Rift and quartersawn white oak shows up on higher-end projects because the grain is straighter and calmer. If you’re working with a designer, send us the spec sheet. If you’re not, we’ll bring sample boards to the house so you can see them in your own light, at the time of day you’re usually home.

Yes. We’ve worked with builders across the Triangle for years, and one local builder has used us for more than 15 years. A builder’s schedule doesn’t leave much slack, so we confirm dates early, show up when we said we would, and send insurance certificates straight to the builder or the site supervisor. Reach us at (919) 794-1116 or [email protected], Monday through Friday, 9 to 5.